Volks: I'm replacing the head gaskets in my Vanagon and have a couple of questions. The heads are finally off and I've put the metal sealing rings in the heads. Where do the thin green O-rings go - around the lip at the top of the cylinder? Bently isn't clear on this. The thicker black O-rings go at the base of the cylinder - can you install them with out pulling the cylinder out past the piston rings? Should I replace it anyway? There was 1 extra O-ring in each one of my my kits - same diameter as the black rings but about 2x the thickness - I have no idea where it goes. What do you think about Permatex gasket sealing compound? I'm also going to replace the fuel hose that goes to all the injectors. Can I get this at the local FLAPS or is it a special VW item? Gary 88GL |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.