Date: Wed, 15 Jul 1998 14:41:46 -0700
Reply-To: marcus <marcus46@FREEWWWEB.COM>
Sender: Vanagon Mailing List <Vanagon@vanagon.com>
From: marcus <marcus46@FREEWWWEB.COM>
Subject: Re: Vanagon O2 Sensors
Content-Type: text/plain; charset=us-ascii
When the 02 sensor went bad these were My symptoms major
hesitation and surging only after normal operating tem. Marcus
John Robson wrote:
> Until recently I have always heard that the O2 sensor doesn't make any
> difference. Now my light is on and the van continues to drive fine.
> Is it worth replacing it?
>
> ______________________________ Reply Separator _________________________________
> Subject: Re: Vanagon O2 Sensors
> Author: Yi-Ruey Wei <ray.wei@US.PWCGLOBAL.COM> at Internet
> Date: 7/15/98 11:47 AM
>
> Good news! You can get a stock Bosch O2 sensor at German Parts &
> Restoration (1-800-321-5432) for $118 + shipping. Just talk to Greg at
> ext. 504. The O2 sensor I've bought from them has Bosch no. 0 258 003 931
> but the sensor from VW dealer has Bosch no. 0 258 003 031.
>
> Yi-Ruey Wei
> 87 Vanagon GL Syncro w/leaking cylinder head
> 85 Jetta GLI w/160,000 miles
> Dallas
> ray.wei@us.pwcglobal.com
>
> Michael Sullivan <sullivan@OPENMARKET.COM> on 07/14/98 06:50:39 AM
>
> Please respond to Michael Sullivan <sullivan@OPENMARKET.COM>
> To: Vanagon@VANAGON.COM
> cc:
> Subject: Re: More 91 syncro troubleshoot ?'s
>
> ------------------------------------------------------------------------
>
> Dear Nathaniel,
>
> This is precisely the same thing that happened to me just two weeks ago --
> I properly installed a "generic" O2 sensor and the engine wouldn't run at
> all once it warmed up. Disconnected ran fine. Bought a "stock" O2 sensor,
> plugged it in and all was well again.
>
> So moral of the story? Either the generic O2 sensor I was sold was bad
> (which I suspect) or the splice that I made was bad (unlkely, as I've done
> WAY too many automotive splices in my day).
>
> Here's to $130 O2 sensors!
> MJS
>
> At 08:18 AM 7/13/98 -0700, Nathaniel Merrill wrote:
> >I ran some more tests. As far as I can tell the sensor is the correct
> one. It also looks identical to the old one. The splice I made was 6
> inches from the sensor and are OK. SO I did not mess with the green
> possibly coaxial cable up on the other side of the connector and the three
> wires to the sensor are not coaxial. None of the pins on the two
> connecters show continuity with ground or the sensor housing. Only the two
> white wires are continuous with each other and the black is not continuous
> with anything. Is this correct? As I understand it the two white wires
> are for the sensor heater. I would expect them to be continuous if this
> was true (but, my old sensor does not show continuity though the two white
> wires-maybe the heating element was burnt?) I also tried what was
> suggested- run the van with the O2 unplugged and check for voltage. With
> the engine at normal op temp there was no voltage between the black wire
> and ground (using a multi meter). Is this the way to test this? Any more
> help is appreciated!
> >
> >>>> Gerald Skerbitz <gsker@x139-110.med.umn.edu> 07/12 7:26 AM >>>
> >The green wire which runs to the O2 sensor is a coax wire. The outer wire
> is
> >a shield of some sort which goes to ground. Make SURE you haven't
> connected it
> >to the O2 signal wires.
> >
> >On Sat, 11 Jul 1998, Nathaniel Merrill wrote:
> >
> >> There recently was a thread regarding poor running of a Vanagon after a
> tune up. I read the conclusions and don't think it covers my problem
> although It is related...
> >> I just installed a new O2 sensor. It was a Bosch which needed to be
> spliced in. I know how to solder and made some fine connections which were
> covered with shrink wrap afterwards. Anyway, it's now running really
> crappy...Smoke, black tail pipe, sounds like it's missing....the works. It
> did run fine before the switch AND I unplugged the O2 sensor and went for a
> test and it ....dare I say, ran great. Whats Up?
> >>
> >
> >--
> >Gerry
> >Gerald Skerbitz <g-sker@umn.edu>
> >U of MN Academic Health Center Administrative Information Systems 6-5379
> >Home St. Paul,Ramsey County,Minnesota, USA
> >
> Michael J. Sullivan
> Director of Catalog Design
> Open Market, Inc.
>
> '87 GL Syncro Westfalia
> ********************************************
> work: http://www.openmarket.com
> vanagon: http://www.hsdesign.com/vanagon
> scan tips: http://www.hsdesign.com/scanning
> ********************************************
>
> ----------------------------------------------------------------
> The information transmitted is intended only for the person or entity to
> which it is addressed and may contain confidential and/or privileged
> material. Any review, retransmission, dissemination or other use of, or
> taking of any action in reliance upon, this information by persons or
> entities other than the intended recipient is prohibited. If you received
> this in error, please contact the sender and delete the material from any
> computer.
>
> ------------------------------------------------------------------------
> Received: from ns2.baxter.com (159.198.1.38) by ccmailgw.mcgawpark.baxter.com
> with SMTP
> (IMA Internet Exchange 2.1 Enterprise) id 004D3204; Wed, 15 Jul 98 11:44:52
> -0500
> Received: from gerry.vanagon.com (gerry.vanagon.com [209.0.14.75]) by
> ns2.baxter.com (8.8.0/8.8.0) with ESMTP id LAA12877 for
> <John_R._Robson_at_NCN001@CCMAILGW.MCGAWPARK.BAXTER.COM>; Wed, 15 Jul 1998
> 11:44:00 -0500 (CDT)
> Received: from gerry (209.0.14.75) by gerry.vanagon.com (LSMTP Lite for Windows
> NT v1.1a) with SMTP id <0.B97CA350@gerry.vanagon.com>; Wed, 15 Jul 1998 9:48:31
> -0700
> Received: from GERRY.VANAGON.COM by GERRY.VANAGON.COM (LISTSERV-TCP/IP release
> 1.8c) with spool id 42612 for Vanagon@GERRY.VANAGON.COM; Wed, 15 Jul
> 1998 09:48:29 -0700
> Received: from aloe.us.pw.com (208.141.52.244) by gerry.vanagon.com (LSMTP Lite
> for Windows NT v1.1a) with SMTP id <0.B7FCBA10@gerry.vanagon.com>;
> Wed, 15 Jul 1998 9:48:28 -0700
> Received: by aloe.us.pw.com; id MAA27053; Wed, 15 Jul 1998 12:40:03 -0400
> Received: from palm.us.pw.com(10.9.16.43) by aloe.us.pw.com via smap (4.1) id
> xmaa26967; Wed, 15 Jul 98 12:39:06 -0400
> Received: from intlnamsmtp10.us.pw.com by palm.us.pw.com (PMDF V5.1-10 #U3018)
> with SMTP id <0EW5001IPABDNQ@palm.us.pw.com> for Vanagon@VANAGON.COM;
> Wed, 15 Jul 1998 12:40:26 -0400 (EDT)
> Received: by intlnamsmtp10.us.pw.com(Internal build - SMTP TEAM v1.2 hotfix3
> (660.3 6-25-1998)) id 85256642.005B90FF ; Wed, 15 Jul 1998 12:40:08
> -0400
> MIME-version: 1.0
> Content-type: multipart/mixed;
> Boundary="0__=V0uSJYkJduZlxPCBHVeaxcWdqm6jr5eXnNccuoMz52b3CYsTNhHk
> KTfC"
> Content-disposition: inline
> X-Lotus-FromDomain: PRICE WATERHOUSE-US@INTL
> Message-ID: <85256642.005AD48D.00@intlnamsmtp10.us.pw.com>
> Date: Wed, 15 Jul 1998 11:47:55 -0500
> Reply-To: ray.wei@US.PWCGLOBAL.COM
> Sender: Vanagon Mailing List <Vanagon@VANAGON.COM>
> From: Yi-Ruey Wei <ray.wei@US.PWCGLOBAL.COM>
> Subject: Re: Vanagon O2 Sensors
> Comments: To: Vanagon@VANAGON.COM
> To: Vanagon@VANAGON.COM
|