Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 1998, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 27 Jul 1998 20:27:38 -0400
Reply-To:     PATT <pdooley@GTE.NET>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         PATT <pdooley@GTE.NET>
Subject:      Re: Warnout  Syncro CV  joint WTB !!!!!
Comments: To: Vanagon@VANAGON.COM
Content-Type: text/plain; charset="iso-8859-1"


I have a spare tranny and some 100mm cv's from a golf GTI.  Rabbit/Golf
inners are available in two flavors, 90 and 100mm.  The 100's seem to have
the same diameter as the vanagon.  I will try to match up a 100mm joint to
the trans I have in storage.  May take a few days, sorry.
BTW, inner race of Golf CV must match van drive axle spline pattern...


-----Original Message-----
From: David Marshall <vanagon@VOLKSWAGEN.ORG>
To: Vanagon@VANAGON.COM <Vanagon@VANAGON.COM>
Date: Monday, July 27, 1998 7:58 PM
Subject: Re: Warnout Syncro CV joint WTB !!!!!




>You should be able to use Audi CVs for this as well.  It wouldn't surprise
>me if any VW / Audi CV will fit.  If someone can confirm that Golf CVs fit
>then you can HAVE the outer set that I have here!
>
>At 12:26 7/27/98 -0400, EMZ wrote:
>>    Anyone have any (bad) outer front CV joint they would like
>>to put to good use. I have a Syncro that I need to keep
>>movable but would like to remnove the front dif. and
>>axles. Without the Front CV joint the front wheel bearings get
>>crushed. I would gladly pay shipping.
>>
>>            Eric                   86-VW4x4
>>            vw4x4@fyi.net          72-240z
>>            Pittsburgh, PA USA     1936-Chrysler
>>
>>
>>On Mon, 27 Jul 1998 vwmaster@VOLKS-MOTORSPORTS.COM wrote:
>>
>>> Mark,
>>>
>>>   I hope this info finds you intime!
>>>
>>>   I have COMPLETE axles, New for $250.00 each.  These are OE dealer
>>> parts left over from the factory!
>>>
>>>   I only have about 6 of these but if you've checked prices of outer
>>> joints and boots along with the labor to do the job you know this is a
>>> really gooo deal.
>>>
>>>   If you want one or two of these let me know?
>>>
>>>   Kyle
>>> --
>>>
>>>   Kyle Wade  (408) 426-1431 OR  (408) 429-9424
>>>   Keeper of the Volks-Motorsports page
>>>   Home Page - http://www.volks-motorsports.com
>>>   ICQ # 3882975
>>>
>>
>>
>
>-- David Marshall, Quesnel BC, mailto:david@volkswagen.org --
>   -- 78 1.8L VW Rabbit, 80 2.0L VW Caddy, 87 Audi 5KQ  --
>   --  85 1.8L VW Cabrio, 88 1.6L VW Syncro Double Cab  --
>   --   Volkswagen Homepage http://www.volkswagen.org   --
>     --  USE DAVID@VOLKSWAGEN.ORG WHEN SENDING PMAIL  --
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.