Date:         Fri, 31 Jul 1998 07:14:46 -0700
Reply-To:     vwmaster@VOLKS-MOTORSPORTS.COM
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         vwmaster@VOLKS-MOTORSPORTS.COM
Subject:      Re: ECU Chip Upgrade Info.
Comments: To: buspilot@WORLDNET.ATT.NET
Comments: cc: vanagon@vanagon.com
Content-Type: text/plain; charset=us-ascii

Lawrence,

  You've done your homework here:)  You also gave GOOD info on the exact
"Job" the chip does as well as what Richard had informed me about Not
running rockers Only like SO MANY of the listees wanted to do.

  I'll still offer the "Kit" so to speak. at the $825.00 if I can get
enough people so I can order 10 kits from Berg.

  I'm still going to do the Dyno Run to post on My web site.

  If anymore of you listees want to sit down, and figure out the cost of
the chip as Lawrence Quoted it, then call Gene Berg and get a price for
the 1.4 Rocker assy, then buy a set of Chromoly Pushrods and cut them to
the correct geometry, I must say that a important piece of info was left
out of Lawrences post and that you neeed to do a slight bit of machining
to the rockers to get them to adjust correctly too.

  Then you all WILL SEE that the $825.00 price tag I offered these at
IS/WAS a good deal since all the work would have been done to the
pushrods and the rockers and all you would have had to do was install.

  Installation of this kit will take a decent tech an Hour.

  I can't wait to see what this round of ECU Rocker thread brings up?

  Enter the Ring for Round #3!!!!!!!!

  Kyle
--

  Kyle Wade  (408) 426-1431 OR  (408) 429-9424
  Keeper of the Volks-Motorsports page
  Home Page - http://www.volks-motorsports.com
  ICQ # 3882975