Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 1998, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 3 Aug 1998 19:53:07 -0700
Reply-To:     Dave Bayer <bayer@SYBASE.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Dave Bayer <bayer@SYBASE.COM>
Subject:      Re: Shuddering rear end -- an update
Comments: To: Vanagon@VANAGON.COM

>| During disassembly, my repair shop noted possible wear on the cross-over >| shaft. When they compared it to a new part, they concluded that the design >| of the part had been changed by VW. We installed a new cross over along >| with a LUK disk. The LUK clutch is listed as a Synchro part, incidentally, >| but it works great in 2WD Vanagons.

Is the crossover shaft the same thing as the release shaft in the bentley (the one attached to the little lever that the slave cylinder pushes down on)?

dave


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.