Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 1998, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 4 Aug 1998 01:27:12 EDT
Reply-To:     Modl6971@AOL.COM
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Michael Modl <Modl6971@AOL.COM>
Subject:      Re: Clutch parts/repair  (Syncro): Help me figure this out...
Comments: To: drew@INTERPORT.NET, Vanagon@VANAGON.COM
Content-type: text/plain; charset=US-ASCII

In a message dated 98-08-03 12:27:30 EDT, drew@INTERPORT.NET writes:

<< 2. I have been in the archives, and see reason to order: clutch, pressure plate, throw out bearing, pilot bearing, felt washers for pilot bearing. What else should I order if I want to have all parts on hand? The manual specifies Ms02 grease. What is that? I have a transmission jack and a garage. Nobody uses special tools for this sort of job, I gather. >> Don't forget the trans mainshaft seal and the rear crank seal. Michael Modl 87 syncro.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.