Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 1998, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 1 Aug 1998 22:47:54 -0400
Reply-To:     Bill Collins <wb6otg@INTREX.NET>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Bill Collins <wb6otg@INTREX.NET>
Subject:      Seam Rust
Comments: To: Vanagon Mailing List <Vanagon@vanagon.com>
Content-Type: text/plain; charset=us-ascii

I started working on fixing some seam rust today (the long horizontal seam at the bottom of the driver's side) and found a small area (a hole about 1/4 inch) that was rusted through. Any suggestions? I'm going to remove the fridge to see if the problem came from an interior water leak (I hope not!)

The seam is filled with some sort of rubber. Is this the way it was done at the factory? If so, what should I use to replace it?

Bill


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.