Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 1998, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 9 Aug 1998 16:43:06 -0700
Reply-To:     Bill Davidson <davidson@SIERRA.NET>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Bill Davidson <davidson@SIERRA.NET>
Subject:      Westy Water Tank Filling
Comments: To: Vanagon List Address <Vanagon@VANAGON.COM>
Content-Type: text/plain; charset=ISO-8859-1

It certainly can be frustrating trying to fill the water tank in a Vanagon Westfalia simply by sticking the end of a garden hose into the inlet hole. It seems there is a plastic partition with three of four holes in it backed up by a rubber flap that covers the entire partition and all the holes. When a water hose is inserted up to the plastic partition and turned on it will only allow a small rate of water (maybe 1/2 to 1 gallons a minute, thus taking about 15 minutes to fill the water tank which is more like 10gallons than the 13 gallons specified in the owner's manual) to enter the tank fill tube. The problem is that the air outlet runs from the tank and connects to the fill box on the tank side of the partition and rubber flap. The water goes glug glug glug as the flap opens and closes to allow water and air to pass each other. The result is that the air return is almost useless because the partition and rubber flap are in the way, forcing the air and the water to fight each other for access to the partition holes, not to mention that any air pressure from inside the tank forces the rubber flap to close against the partition! My solution: Go to the hardware store and buy the proper fittings (I used brass) to step down from 3/4 inch hose threads to male barbed tubing fitting. Pick the size tubing such that the outside diameter just fits through one of the holes in the plastic partition (I used about 6 inches of clear water potable tubing and beveled the end to make it easier to insert). Slip the tubing on the end of the male barbed fitting and connect the 3/4 inch hose fitting to the hose. Insert the tubing end into one of the holes in the partition, thus pushing the rubber flap back. Insert it far enough to get past the air outlet (about two or three inches). Now you can fill your tank in about 2 or 3 minutes with no spillage of water. I also bought a cheap on/off valve to fit into this setup just after the garden hose so I can quickly turn the water on and off without having to run back to the faucet. This set up has really worked well for me and saved a lot of time and frustration and guess work as to weather my water tank is full or not!! Good luck... Bill Davidson... Westy Syncro '90


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.