In a message dated 98-10-05 18:23:14 EDT, jbaker@APBOARD.COM writes: > Could I get one of you to give me a brief conceptual explanation of how > cruise controls work. > I have always wondered plus I need to fix mine. Basically there are 4 parts. Speed Sensor - Can measure rotational speed of an axle, a driveshaft, or engine. Most systems use the pulses of the ignition coil to measure the speed of the engine. Some aftermarket systems use magnets attached to the axle or driveshaft and a sensor that counts the rate at which the magnets pass. I installed one of these on a Diesel Rabbit Pickup - no coil pulses! Driver Switches - Used for on/off, accelerate, decelerate or coast, etc. Controller - Takes inputs from speed sensor, driver switches, etc and determines proper actuator position. Acutator - Typically a vacuum powered device that pulls open the throttle when more power is needed, allows throttle to move toward closed when less power is needed. Here's how the pieces function together. The driver sets a "setpoint" of the desired speed. The controller determines the actual speed, as measured by the speed sensor and compares it to the setpoint. If the two match, no action is taken. If there is a difference between the actual speed and the setpoint, the controler causes the actuator to move to either open or close the throttle a little, depending on whether actual speed was above or below setpoint. By now about 1/4 second has gone by and the controller goes through the routine all over again. Other inputs can come from the brake pedal position, and clutch pedal position. Sometimes the controller and actuator are assembled together into a single unit. Most units also have a function whereby if the actual speed if too far from the setpoint the unit automatically turns off. Hope this helps. Regards, Jim Davis |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.