Date:         Fri, 9 Oct 1998 11:40:04 -0700
Reply-To:     John Eavis <jhe@INFOMAGIC.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         John Eavis <jhe@INFOMAGIC.COM>
Subject:      driving syncro without a driveshaft?
Comments: To: "Vanagon@VANAGON.COM" <Vanagon@VANAGON.COM>

The U Joints have gone bad on the driveshaft of my 87 syncro. I have found
a good machinist to replace them but am wondering if it will cause any
damage or problems to operate the vanagon without the drive shaft while
this is being repaired. Any opinions appreciated.

Thanks!!

John
87 syncro vanagon

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.