Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1998, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 8 Oct 1998 13:27:37 -0700
Reply-To:     Dave Bayer <bayer@SYBASE.COM>
Sender:       Vanagon Mailing List <Vanagon@vanagon.com>
From:         Dave Bayer <bayer@SYBASE.COM>
Subject:      Using gas inline 4 manifold
Comments: To: vanagon@vanagon.com

Hello- For all of you out there have pushed gas inline 4 into your vans - did you use an exhaust manifold that used those spring clamps to secure the manifold to the exhaust pipe? If so, how did you remove and replace those clamps?! I was told there was a special tool to do this but have not found anything in the three stores I have been to that act anything like what was described to me...

dave


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.