It's a governor designed to keep your splitscreen from speeding through the sound barrier. Keep it if you're a stickler for authenticity, replace it with a short flange/pipe part if you're not. Luke Seattle, WA ---------- > From: Jimmy Sanby <sanbyj@TELKOM.CO.ZA> > To: vanagon@VANAGON.COM > Subject: '67 Type2 question > Date: Thursday, October 22, 1998 10:54 PM > > A friend of mine has just purchased a 67 Kombi and we are puzzled about > a peculiar "gizzmo" between the inlet manifold and the carb. It seems to > have two purposes in life: > 1. To act as a 50mm spacer to lift the carb in height. > 2. This is why I am asking..... It is made out of the same material as > the carb. attached to the spacer is a vertical container about 20mm > thick, +/- 70mm wide and +/-100mm high. There is a plate covering the > container. It has no wires or pipes attached but it does have a lead > seal with a VW stamp on it holding the plate in place.. > > Any ideas? > > Thanks > > Jimmy Sanby > Cape Town > South Africa > '89 Syncro 15" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.