Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 1998, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 26 Oct 1998 04:02:04 -0800
Reply-To:     Per Lindgren <lindgre@ONLINE.NO>
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Per Lindgren <lindgre@ONLINE.NO>
Subject:      Re: Syncro cv-joint fun
Comments: To: vanagon@vanagon.com
Content-Type: text/plain; charset=us-ascii

Mark Drillock wrote:

> The torque for the 46mm nut is 500 Nm or 350 ft lb. from the Bentley page 42.4

Are you sure of this? I would need the V12 engine from a benz to get this much torque!

>Are you saying that you were able to push the axle out of the housing without first

> removing the housing? What force did you use to push it out? This is supposed to > require a hydraulic press to remove the shaft and to put it back in. I have replaced > the rear wheel bearings on a couple of my Syncros and there was no way to push the > shaft out without pounding with a large hammer. This deformed the threaded part of > the shaft so I stopped and followed the Bentley procedure.

I just knocked it with a 1 kg hammer and a socket extension bar, it came out without too much effort. I remember changing the right rear bearing on my 73 Sqback once, and it was a pain in the butt to get out, so I was a bit amazed at this. Would I need to change the bearing too? I feel the wallet beeing drained, the bearing shows no sign of beeing worn. I think Mr. Murphy is becoming a good friend of mine :-o

PerL


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.