Date:         Tue, 10 Nov 1998 00:18:21 -0500
Reply-To:     moon <moon@BINTERACTIVE.COM>
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         moon <moon@BINTERACTIVE.COM>
Subject:      Fw: Syncro Driveshaft
Comments: To: Vanagon@VANAGON.COM
Content-Type: text/plain; charset="iso-8859-1"

hello all!

i am very curious about this same subject.

reading the messages this evening i wondered something new.

assuming it was necessary to install the driveshaft in a certain position,
if the van was driven with no driveshft, over the course of time could the
front and rear connections for the driveshaft become 'out of sync' -
rotated to different points - causing the parts in the front to be in a
different relative position than before? could this matter?

any thoughts?

moon

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.