Date:         Tue, 10 Nov 1998 10:47:26 -0800
Reply-To:     Dave Bayer <bayer@SYBASE.COM>
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Dave Bayer <bayer@SYBASE.COM>
Subject:      syncro front inner CV circlip and dished washer
Comments: To: vanagon@vanagon.com

After Michael's assurances that using the socket would work seat the
circlip, I went out measured the driveshaft and bought a 27mm socket. This
did the trick in about 5 blows of the mallet. A definite change in the sound
the impact of the mallet-extender-socket-circlip-driveshaft accompanied the
seating of the circlip. I had tried it with a 29mm socket before writing the
list last night but could not get the circlip to seat. Thank you Michael for
getting me to give it another go...

dave

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.