Date: Fri, 20 Nov 1998 12:36:26 -0500
Reply-To: James Wagner <wagner01@EROLS.COM>
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: James Wagner <wagner01@EROLS.COM>
Subject: Re: simple engine RPM question--need shifting advice
Content-Type: multipart/alternative;
I think a distinction should be made between what an engine is capable
of doing to produce the most power and what is necessary for given
conditions. I know when my 85 GL was fairly new, 1989 or so, it was a
terribly peaky engine. It was very hard to drive because it had no
power off the bottom and then had a really massive surge at about 2800
rpm. First gear could hardly be used because it was so difficult to
just get the van rolling without tearing forward with a roar. In the
higher gears it was manageable and certainly usable at rpms around
2000. But basically the engine was made to deliver high peak power at
the expense of drivability. It was not a good match to the needs of
drivers on public roadways.
Phillip Bouton wrote:
> From: Dave Ohlemacher [mailto:Dave@ohlemacher.com]
> Sent: Friday, November 20, 1998 10:10 AM
> To: Phillip Bouton
> Subject: Re: simple engine RPM question-need shifting advice
>
> German engines are made to hug the redline, at 3500, you're a long way
> off. Besides, I think (and have read) it's harder on an engine to
> struggle through a higher gear at low rpms. What you don't want to do
> is keep it at 5000 rpm for an extended period of time, that causes
> undue stress, but to run it up to 3500-4000 when shifting is fine.
>
> Needles to the right!
> Dave
> 86 Vanagon GL
>
> Phillip Bouton wrote:
>
> >
> >
> > I also have been perplexed by the same issue. The manual says
> to stay
> > in the green. On my 87 Westy that is between 2 and 4k rpm.
> Europeans
> > would rather sacrifice an engine to save gas in the long run
> because
> > gas is so expensive. In my van it seems that in order for the
> next
> > higher gear to start around 2k, you definitely need to be
> shifting
> > around 3500 or higher. Otherwise the next higher gear will be
> between
> > 1.5 and 2k. However, I can't say that I do this consistently
> because
> > it is so hard to let myself rev the engine that high in the
> lower
> > gears. Does anyone have any reassurances or other comments?
> >
> > ><><><><><><><><><><><><><><><><><><><><>J
> > Phillip Bouton
> > -----Original Message-----
> > From:Jarod Bishop [mailto:jbishop01@FOXINTERNET.NET]
> > Sent:Thursday, November 19, 1998 7:38 PM
> > To: vanagon@VANAGON.COM
> > Subject: simple engine RPM question
> >
> > I recently bought an '87 Syncro. Having never owned a VW, I'm
> not
> > used to
> > running the engine at a higher RPM rate like people have told
> me.
> >
> > The speed seems to max out at around 3500 but I give some more
> gas and
> > get
> > it past 4k before shifting, but I've heard you should go
> atleast 4.5k
> > or
> > 5k. I was hoping to get input on what others typically run
> their vans
> > at
> > before shifting up.
> >
> > Thanks
>
--
James Wagner
[text/html]
|