Date:         Tue, 17 Nov 1998 22:37:38 EST
Reply-To:     SBate82659@AOL.COM
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Sam Bateman <SBate82659@AOL.COM>
Subject:      Re: Rear Bumper Concerns
Comments: To: vanagon@vanagon.com
Content-type: text/plain; charset=US-ASCII

In a message dated 98-11-17 21:05:24 EST, MW575@aol.com writes:

<< I went to a local welder and asked about welding something that would fit
 between the brackets the bumper bolts to, and would fit inside of the current
 flimsy bumper.  He said he could weld a 2" x 3" tube between the brackets,
but
 was concerned about what might happen in a crash to the frame - it could be
 bent more than it would without such a modification.   The welder said he
 could do the job for $100, which seems like a cheap insurance policy in the
 case of a 5-10 mile bump, if it would do the job of protecting some of the
 engine.  Any thoughts anyone? >>

MW,

On my '87, the trailer hitch that I installed (Valley Hitch) fits inside the
rear bumper as you described and bolts to the two bumper-support arms that in
turn bolt into the frame.
It's cross-member (that fits inside the bumper) is approx. 2" X 2" , 3/16"
steel tube.
If I remember correctly, that hitch cost approx. $80.00 from Sears.
Somewhat cheaper than your local welder and you'd be able to pull a trailer if
ever inclined.

Just something to consider.......


Sam Bateman
Fork Union, VA
'87 Vanagon GL