Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 1999, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 4 Jan 1999 18:32:55 -0500
Reply-To:     jhlauterbach <jhlauterbach@EMAIL.MSN.COM>
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         jhlauterbach <jhlauterbach@EMAIL.MSN.COM>
Subject:      TEMP I SENSOR

The Temp I sensor on my '84DL (1.9L gas engine) appears to have gone "crazy" with the advent of cooler weather here in the Deep South. After about 1 minute after the engine is started, temp needle moves to mid gauge or higher. Then sometimes it will drop to almost dead cold. Is this typical of a bad sensor? Coolant level is high enough to keep the flashing LED off, but I am probably a couple of quarts shy of full.

If it is a bad sensor, any "gotchas" on removing the old and installing a new one?

John Lauterbach


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.