Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 1999, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 15 Jan 1999 06:38:42 EST
Reply-To:     kenneth d lewis <kdlewis@JUNO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         kenneth d lewis <kdlewis@JUNO.COM>
Subject:      Re: Bleeding Cooling system per Bentley
Comments: To: jrasite@EONI.COM

Jim; Great response! Allow me to add one detail that befuddled me the first time. I was expecting the bleeder valve in the engine compartment to bubble out to the atmosphere. Instead it purges bubbles to the expansion tank via the small hose. This may seem obvious to some but I thought it was stopped up and removed the whole thing for inspection. Drive Safely & Good Luck Ken Lewis<Kernersville,NC>86 VW crewcab;60 T-5 Coupe

On Thu, 14 Jan 1999 22:45:50 -0800 Jim Arnott <jrasite@EONI.COM> writes: >John, > >Here's how it's done. (per Bentley pgs. 19.16-19.17) > >1. raise front end about 40 cm (15 3/4 in.) >2. set heater control to max heat >3. open control valve for rear heater >4. remove grill >5. open bleeder screw on passenger side top of radiator >6. open bleeder valve at front of engine compartment (on black >plastic >fitting with 4 large radiator hoses connecting to it.) >7. fill coolant until expansion tank the one on the left, NOT the >overflow >tank on the right.) is full (approx. 4-5 liter (4.25-5.3 US qt.)) >8. start engine >9. at approx. 2000 rpm fill expansion tank until coolant flows from >bleeder >screw in radiator bubble free (it takes two people!) >10. add coolant until expansion tank is full and close tank with cap >11. turn ignition off and start engine again after about 20 seconds >12. raise engine speed to approx. 2000 rpm and open cap of expansion >tank >13. close bleeder screw on radiator when coolant flows out (need that >friend again!) >14. add coolant if necessary and close tank >15. close bleeder screw in engine compartment >16. turn engine off >17. top up overflow tank >18. reinstall grill >19. lower front end >20. drive for a couple days and keep an eye on the coolant level. (my >suggestion, not VW's) <snip> >Jim Arnott >WetWesties >Union, OR >

___________________________________________________________________ You don't need to buy Internet access to use free Internet e-mail. Get completely free e-mail from Juno at http://www.juno.com/getjuno.html or call Juno at (800) 654-JUNO [654-5866]


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.