Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 1999, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 15 Jan 1999 09:16:15 -0800
Reply-To:     "Pollard, Matthew" <Matthew.Pollard@OREADCA.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Pollard, Matthew" <Matthew.Pollard@OREADCA.COM>
Subject:      Erratic Idle Solution?
Content-Type: text/plain

> -----Original Message----- > From: Matthew Denette [SMTP:mdenette@net1plus.com] > Sent: Friday, January 15, 1999 9:10 AM > To: Matthew.Pollard@OREADCA.COM; pbj2003@INFONET.ST-JOHNS.NF.CA; > Jbmorris@RA.ROCKWELL.COM; dearbo@EROLS.COM; vickrail@VELOCITY.NET; > geohahn@AZSTARNET.COM; sneakers@EMERALD.OZ.NET; DanielisOk@AOL.COM > Subject: > > Dear Sir, > > I didn't believe it. It worked. It cost nothing. Our Vanagons are running > great!! > (our family has owned over 48 VW's. 12 of which were Vanagons, 6 are still > in use) > The oldest of the seven kids delivered this solution to me. It sounded > dumb and too simple. I also didn't want to admit, after all I had spent, > that I had wasted so much money. I tried it. It works great! I was wrong. > > Here is the premise: The air breather box is polyethelene or polyvinyl. It > builds up static electricity, like a cheap rug or my brother's leisure > suite. The only place for the static electicity to discharge when it > builds up is through the sensors for the fuel injection system. This is > what causes symptoms like eratic idle, bucking, chugging, etc. Mine seemed > like it had ice or something in the fuel line when it does it. Sometimes > it would stall while driving. > > Here is the very CHEAP cure: Take a piece of wire about 2'-3' long. Strip > a little and attach it to a bolt on the engine, or any other good ground. > Drill a very small hole in the air breather box; just big enough to insert > the wire. Strip about a foot of wire and thread it through the little > hole. (I fanned out my wire and it worked even better) With just a little > silicone sealant or chewing gum, seal around the wire (optional). > > Here is the result: Our Vanagons run great!! No bucking. No Chugging. No > erratic idle! No stalling! Fun driving again! Please try it. If it works > for you, too, spread the word.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.