Mitch, With the isolator setup, there is no other way but to run another wire from the isolator to the aux. battery. I guess that is the reason most use a relay. The relay: If I would use a relay I would still run a # 6 ga. wire from the main batt. to the aux. batt. with a marine 40 amp. relay or something like that. The VW relay: I am probably going to get flamed for this, but I believe the factory relay under the front seat that most westies have is designed by VW to only power the refrigerator 12 volt heating element. There is a possibility that, if one is using that to also charge a second battery, that the relay or the wiring could be damaged. It is fuse protected, but still.... That setup works for a lot of people, but it is good to at least keep an eye on it. Imho. Back to the isolator. The isolator is kind of neat, because both batteries are always isolated. It does not matter if they are being charged or discharged. One battery could be totally dead and the other strong, it would not matter. On the setup I am using, the deep cycle battery is under the drivers seat, and I mounted the isolator in the engine compartment behind the right rear wheel well. In that space by the rear light, and the air intake. The isolator should be mounted as close as possible to the alternator. To run a # 6 ga. wire from there to the left front batt. box was not all that difficult. I ran the wire inside some clear vinyl hose that I got from the local hardware store, as added insurance against chaffing. There are lots of places under the van that one can fasten the vinyl tube to with cable ties. Some tips for wiring: Have lots of cable ties handy. Use rubber grommets when routing through a bulkhead etc Install a small fuse panel for the accessories you run from the aux. battery. Route critical wires in conduits (like clear vinyl hose) under the van. Buy a small block of electricians putty for sealing off openings, protecting exposed contacts from moisture, etc. That stuff has hundreds of uses around a vanagon. Invest in a strong crimping tool. They sell some better ones in the electrical section in the hardware stores. When routing wires, give them some extra slack. And of course, there are many different ways to do anything. Have fun. Harald 90 westy Mitch wrote: > I'm installing a second battery in my 84 Westy and would like to > do it right the first time. > My question is where is the best place to install the isolator so > that I don't have to run another wire up to the extra battery from the > isolator (if it were mounted in the engine compartment) is there another > place? > > Any help would be greatly appreciated Mitchell 84 westy > mmiller@neteze.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.