> >> "Flux" is NEVER necessary in typical electrical wiring soldering!!! >> Rosin is NOT "corrosive", in any way! I have some home-brew & radio >> kits I built back in the 60's and later and I defy anyone to find any >> evidence of any rosin-induced "corrosion" in any of these pieces of >> equipment! In fact, me grandmother's '37 Philco AM-SW radio still works >> fine and, virtually, everything in it is "soldered" together. >> > A radio presents a completely different environment to a motor vehicle. > There is no vibration in a radio and little temperature variation. An there is never any exposure to moisture and corrosive chemicals inside a radio. Joshua Van Tol -- jjvantol@uswest.net |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.