In addition to reducing the pump cover clearance to .000" WITHOUT the gasket (use the gasket when installing...) The oil inlet and exit can be matched to the case oil passages. The oil passage on my case was larger than the exit tube (the smaller of the passages in the pump) I opened the tube to match the passage size in the case. I also chamfered the edges of the tubes leading to the inside of the pump to increase oil volume. Pressure is controlled by the spring... Robert
_______________________________________________________ Get your free, private email at http://mail.excite.com/ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.