> >From Jeff: > >Would any of you know the best course of action to take when your > >mechanic says you have leaky head gaskets? New gaskets, heads, engine? How > >about the 2.1L to replace my 1.9? Will the same wiring harness work? Mine > >is an 85 GL< > > >From Kit Carter: [snip] >Okay, now re the immediate problem at hand, the head gasket job can be done >with the engine still in the van. If your mechanic says that is his intent, >you might consider replacement of the water pump and the thermostat while >you are at it. [snip] >From Jeff: > Thanks to all of you for the input. As money is a trmendous object, I'll > save my dimes. -Jeff Jeff, one more piece of advice -- if you're doing the heads yourself, remember to at least stretch out the push rod tubes before you put them back in. Consider buying new ones. I didn't do this and was rewarded with two leaky push rod tubes -- one on each side. I bought the two piece replacement tubes which are working fine, but I would have saved time and money by replacing them in the first place. ----- Fred Younger |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.