Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 1999, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 13 Feb 1999 15:24:48 -0500
Reply-To:     Gary E Thaxter <gthaxter@DGTDESIGN.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Gary E Thaxter <gthaxter@DGTDESIGN.COM>
Subject:      how to get 360ft-lbs torque?
Content-Type: text/plain; charset="us-ascii"

Does anyone know of any way to torque axle nuts to the torque specified without driving to a garage that has a 4-foot torque wrench.

I have heard about using an extender bar, and a smaller torque wrench, but I don't remember the math.

Any suggestions would be great.

Thanks

Gary Thaxter 74 transporter (panel) 78 westy 85 kombi 86 syncroGL


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.