The Haynes manual suggests the procedure as: At TDC, tighten the screw, then loosen it until it is barely off the valve stem, then turn it back until it just touches, and from this position tighten them EXACTLY 2 TURNS, and then tighten the nut without moving the screw at all. Hope this helps. PerL 88 Syncro |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.