Dennis: It's clear that I've been too timid about applying the heat. I'll try again tomorrow and be a little more aggresive. Thanks.
On Wed, 24 Feb 1999, Dennis Haynes wrote: > You need to heat it up to about 300 degrees. I use a bearing heater but a > torch will also do. A good machine shop supply will have markers you can > get that melt at different temperatures. You don't wan to get he gear too > hot as it can warp. --------------------------------------------------------------------- Tom Young young@sherlock.SIMS.Berkeley.EDU Lafayette, CA 94549 '81 Vanagon --------------------------------------------------------------------- |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.