> > The best option in my mind, if all the parts are available and in equally > good condition, would be to use the 2.1 cooling system and exhaust system, > but use the Digijet electronics. The only necessary alteration you would > need to do is to add a single-wire oxygen sensor to the exhaust system. > > Bill Actually, except for the heater, the three wire oxygen sensor works exactly the same as the single wire type. Just hook up the signal wire, and leave the heater wires disconnected. Joshua Van Tol -- jjvantol@uswest.net |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.