Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 28 Feb 1999 11:04:53 -0800
Reply-To:     Dana E Hager <dehager@IX.NETCOM.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dana E Hager <dehager@IX.NETCOM.COM>
Subject:      WESTY - new manchester LP tank valve question
Content-Type: text/plain; charset=us-ascii


I just purchased a new LP tank for my '87 Westy Syncro from Manchester.
I
wanted to replace the two copper lines and fittings because they were
very
coroded. I can't seem to find a left threaded reducing bushing to go
from the
tank valve to the regulator. Also, the nipple was welded to short and
now I
need to use a couple of 90's comming off the valve to bring the
regulator out
far enough to spin on. Any ideas on installing a new regulator and tank
on a
'87 Westy would be apprieacted.


Dana E Hager
Nazareth, PA
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.