Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 22 Feb 1999 07:36:07 -0500
Reply-To:     EMZ <vw4x4@FYI.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         EMZ <vw4x4@FYI.NET>
Subject:      Re: Head Sealant
Comments: To: "John C. Iseman" <JIseman457@AOL.COM>
In-Reply-To:  <8f6625a9.36d0f3c0@aol.com>
Content-Type: TEXT/PLAIN; charset=US-ASCII

Warning ! I used the "recommended" Permatex stuff, the first time I did the heads on my old Vanagon. Less then 5000 mile I had to do it again!!!!!!!!!!!!!!!!!!!!!!!!

Eric 86-VW4x4 vw4x4@fyi.net 72-240z Pittsburgh, PA USA 1936-Chrysler

On Mon, 22 Feb 1999, John C. Iseman wrote:

> I have used high temperature silicon sealant in many appplications with > excellent results. Would such a sealant be suitable for use on a head gasket > replacement job ? > JIseman457@aol.com >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.