On Thu, 4 Mar 1999, Gary Basey wrote: > > But now I have a new problem. I removed the engine/trans from my '80 > Westy to rebuild the engine. Upon separating the trans from the engine, > the mainshaft came out. I searched the archives and found no reference > to this problem. I've been told it's probably a broken snapring. > > I've been quoted $120 to replace the snapring, is that fair? > Could a novice do this job? Do it yourself. If that is all that is wrong it's an easy fix. Start by removing the bell housing, thats simplly a matter of unbolting it. Take a look around and see if there is any signs of other damage. (unlikely) That shaft is held in by a stud in the end of the shaft (shaft to shaft) and a spline sleeve over top that you slide into place. Then a clip ring that hold it from sliding back. Let us know waht you find. Eric |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.