Dear Listees: I'm hoping someone can help me with the following problem. The red LED in the temperature gauge will not stop flashing after I turn on the ignition/start engine. The temp gauge itself works fine and the seat belt buzzer/light times out after 3 seconds as it should. I have replaced the instrument pod and compared the coolant level switch (in the expansion tank) and the coolant sensor (next to temp sensor II) with known good ones with my ohm meter and they seem fine. The "coolant low level warning sensor module" (relay marked #43 on firewall) was found to have a burned resistor internally and was replaced. I have also tracked down a broken ground wire to the firewall and original instrument pod had some burned out resistors and tachometer. Does anybody have any ideas? Please resond to my e-mail address. Thanks!!! Cary Chiang chiang1@usa.net '85 Westy
____________________________________________________________________ Get free e-mail and a permanent address at http://www.netaddress.com/?N=1 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.