Date:         Sat, 13 Mar 1999 19:13:35 -0800
Reply-To:     Randolph Feuerriegel <RFeuerriegel@BC.SYMPATICO.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Randolph Feuerriegel <RFeuerriegel@BC.SYMPATICO.CA>
Subject:      Audi gauge cluster installation
Content-Type: text/plain; charset=us-ascii

Greetings all.

Well, after carefully twisting & pulling I got the heater panel off. I
was dismayed though to find I could only fit 2 gauges in below the diff
lock panel. The heater pipes are in the way. I was also hoping to use
the Audi panel with the angled holes. I may still use it by trimming one
slot off. On the back of the heater panel there are support/flex braces
which interfere with cutting. Does one cut through them or just mount
the gauges down low? Any advice appreciated.
--
R.Feuerriegel
88 syncro

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.