synergx@IBM.NET writes: << How much sideplay is normal in the main shaft? >> Some, but not too much. << How much seepage from the main shaft oil seal is normal? >> It shouldn't seep at all << How close to parallel does the clutch release fork need to be? >> ?? It'll ride where it rides due to the slave cylinder pushing down on the lever arm. << How much wear is acceptable on the ends ("tines") of the release fork? >> Very little. The ends should be nice and round where the T/O bearing pivots. -Todd Hill VolksWerks Transaxles Olympia, WA 360-412-0948 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.