Date:         Wed, 7 Apr 1999 20:21:14 -0400
Reply-To:     paul banks <paulbanks@NLLFAN.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         paul banks <paulbanks@NLLFAN.COM>
Subject:      Re: 15

On Wed, 7 Apr 1999 19:10:40 -0500 Joshua Van Tol <jjvantol@uswest.net> wrote:

>
>You're aware that the center hub hole can be machined out to fit, right?
>
>Hi Joshua,

The hole would need much machining to get it to fit. I was worried that the rims would lose their structural integrity if machined too much.

Does anyone else have an opinion on the above?

Thanks,

Signup for your FREE NLL FAN account at http://www.nllfan.com

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.