Hi all, On Sat, 1999-04-24 21:28:54 -0700, Markus Benne wrote: > ... > How does one transport a syncro without an engine? Apart from your own proposals, you could also remove the drive shaft. It's only eight nuts and bolts (13mm, sometimes 12mm, open wrenches only). Before unbolting you should mark the rotational alignment of all the flanges on both ends, so you are able to re-assemble everything exactly as it was before. With drive shaft removed, you could then simply pull her or use a dolly. I hope this helps. Sincerely Rainer '89 Caravelle GL Syncro 16" ---------------------------------------------------------------------- | Rainer M Woitok | Phone: (+49-9131) 85-27811,-27031 | | Regionales Rechenzentrum | | | Friedrich-Alexander-Universitaet | Fax : (+49-9131) 30 29 41 | | Martens-Strasse 1 | Telex: d 629 755 tf erl | | D-91058 Erlangen | | | Germany | Mail: Woitok@RRZE.Uni-Erlangen.DE | ---------------------------------------------------------------------- |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.