Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 25 Apr 1999 15:32:06 -0700
Reply-To:     Markus Benne <markus@CYBERUS.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Markus Benne <markus@CYBERUS.CA>
Subject:      Removing rear axel and CV on Syncro
Comments: To: vanagon@vanagon.com
Content-Type: text/plain; charset=us-ascii

I'd like to move a syncro and use a dolly. Sounds like a good way to do this is to remove the rear axels and CV joints.

Unfortunately, I have never seen a syncro up close and don't have the Bentley.

If some kind Syncronaut could tell me how hard this is to do and what types of tools I would need (like a lift?) I would appreciate it.

You can p-mail me as this is probably not of general interest (I do monitor the list tho).

Thanks a heap, ...Markus


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.