Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 28 Apr 1999 00:26:20 -0600
Reply-To:     Larry Hamm <ldhamm@XMISSION.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Larry Hamm <ldhamm@XMISSION.COM>
Subject:      Re: Vanagon Rear Bumper Needed
Comments: To: Stuart MacMillan <stuart@COBALTGROUP.COM>
Content-Type: text/plain; charset=us-ascii

Stuart MacMillan wrote: > Only a bumper made of quarter inch > thick steel channel would have prevented the $800 worth of damage

Stuart, I found that bumper at the pick 'n pull. It's 5" high and 2" deep. The channel was welded to the original bumper mounts, and the ends had little flat pieces welded on to roughly match the original bumper. It now graces the back of my Westy, and it even has a hitch ball mounted on a small flange. Larry


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.