Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 1999, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 28 Apr 1999 10:13:47 -0400
Reply-To:     The Bus Depot <ron@NETCARRIER.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         The Bus Depot <ron@NETCARRIER.COM>
Subject:      Re: German parts Was: Rear Bumpers
In-Reply-To:  <372707D6.550C@cyburban.com>
Content-Type: text/plain; charset="iso-8859-1"

> It is also wise to note that "German" parts now means the same as > formerly "West German" or "East German" parts. > > Well West German parts may have had a good reputation, but anything > coming out of East Germany was pure junk. Who knows where "German" parts > now come from? >

While you are theoretically correct, I don't know of any East German made Vanagon parts on the market right now. Most are coming from companies that have had established West German factories long before the union. However, as we witness the continuing development of a global market, it is now quite common for a "German" manufacturer to make their parts outside of Germany entirely. For example, I have seen FAG bearings made in Japan and Brazil, and ATE brake drums are now made in Italy. Even "dealer" parts purchased from the VW dealer are now often in fact coming from VW of Mexico or VW of Brazil. The good news is, so far I have found little or no quality difference between the German and other products sold by the better brands such as ATE and FAG. It seems that these well-reknowned companies' attention to quality extends to the products they make (or have made) elsewhere as well as those they make in Germany, which is perhaps one benefit of dealing with a well-established brand that has a reputation to uphold. But it does mean that I am being more careful to use the term "original equipment supplier" rather than "German supplier", since the German company's box may not always contain German parts. As time goes on, identifying actual country of origin may get even more difficult, as "Made in EEC" (European Economic Community) or "May Contain Parts from One or More of the Following Countries" are sometimes being used on some boxes instead of actual country of origin.

- Ron Salmon The Bus Depot http://www.busdepot.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.