Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 1999, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 Apr 1999 22:15:42 -0700
Reply-To:     Derrek Wittmann <derrekw@CMC.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Derrek Wittmann <derrekw@CMC.NET>
Subject:      Re: Problems with the u-joints of the driveshaft
Content-Type: text/plain; charset="iso-8859-1"


Has anyone considered replacing the bushings that support the transmission
and front differential / VC.  If these bushings wear out over time they
might affect the alignment of the running gear or deformed under specific
load conditions resulting in a vibration of the drive shaft.  Let me know
this makes any sense or anyone has the success in correcting this type of
vibration.  I haven't 86 syncro that vibrates at around 50 60 but goes away
above 60 miles an hour.  I've not yet done anything to try to resolve this
problem.


Derrek
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.