Thanks Tom: I think the problem is that the fellow at the garage, who removed the inner race (needed a hydraulic press) , so I could put in a new boot, installed the inner race BACKWARDS. I will confirm this tomorrow. BTW: Your web site is very helpful, and I used it as a reference. One thing though, I have 12 point bolts, but they are 10 mm, not 6 mm. I now have an extra 6 mm 12 point tool! Cheers! Marshall -----Original Message----- From: Tom Carrington <tcarrington@relitech.com> To: 'Marshall Ruskin' <mruskin@PANGEA.CA>; vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM> Date: Saturday, May 01, 1999 9:03 PM Subject: RE: Serious problems with CV reinstall -HELP!
>The real trick is to properly line up the inner and outer races. There are >pictures of the proper alignment at: > >http://www.relitech.com/tomc/cvjoints.htm > >The joints can be disassembled and re-assembled with the inner race still >on the half-shaft. You just can't replace the boots with the inner race >still on the half-shaft. > >Good luck! > >TomC >tcarrington@relitech.com >http://www.relitech.com/tomc/tomvw.htm > >-----Original Message----- >From: Marshall Ruskin [SMTP:mruskin@PANGEA.CA] >Sent: Saturday, May 01, 1999 7:28 PM >To: vanagon@GERRY.VANAGON.COM >Subject: Serious problems with CV reinstall -HELP! > >Volks: > >I'm having real trouble reinstalling my cv's - I think I may have done it >wrong, here's the problem: > >I have my half axle out. The inner race, and bearing cage are on the half >axle. Problem is, I can't get the outer race back on. > >Where I think I'm in error, is that I NOW! think the inner race has to be >removed from axle, and entire CV reassembled first, then pressed back onto >axle. > >What is strange here is that the outer race came off, basically, all by >itself, without any jiggling or wiggling etc. Now I can't get it back on. > >The "complicating thing" is that my inner races are extremely tight on the >axle, and I had to get one pressed off by shop hydralics to slide the >replacement boot on. > >So, should I buy a gear puller, to remove said inner race, and then >assemble >cv and pound back onto axle? Or is there some way to get outer race onto >CV, >with inner race still on half-axle? > >TIA > >Marshall Ruskin >84 Westy "Iron Igloo" >Founding Member of "Vanagon's Anonymous" > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.