Date:         Mon, 3 May 1999 10:59:05 -0700
Reply-To:     Stuart MacMillan <stuart@COBALTGROUP.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stuart MacMillan <stuart@COBALTGROUP.COM>
Organization: The Cobalt Group
Subject:      Re: wheel bearings
Comments: To: Björn Ratjen <bratjen@DIRECT.CA>
Content-Type: text/plain; charset=us-ascii

Bjorn,

You have a spun bearing, not a good thing.  It also sounds like the
bearing seat in the hub wore down as well as the bore since the nut was
loose. The hub is probably scrap.  You might take it to a machine shop
for evaluation, but I think you should start looking for a used hub
assembly.

Be sure to replace the seals on both sides and just clean and re-pack
the bearings that are still good with a high quality wheel bearing
grease.
--
Stuart MacMillan
Manager, Case Program
800-909-8244, Ext. 208

Getting your share of the Net yet?

http://casedealer.com/demo
http://caseihdealer.com/demo
http://cobaltgroup.com