Date:         Sat, 1 May 1999 19:58:01 -0400
Reply-To:     "Joe L." <jliasse@TOAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Joe L." <jliasse@TOAST.NET>
Subject:      Re: Rebuiliding brake master cylinder
Comments: To: Debi <mtngal@SIERRATEL.COM>
Content-Type: text/plain; charset="iso-8859-1"

     If memory serves, when I replaced my MC a couple of years ago, there
was not that much difference between the price of a rebuild kit and a new
cylinder; something like $10 or so.
    Replacing the MC was the first time I had worked on breaks and I was
VERY nervous going in. Turns out that the job is not that hard at all.
Bleeding the breaks is also not that hard but IS something of a pain as you
need to get someone to pump the breaks while you crawl around under the van
shouting "UP/DOWN/HOLD". That is, unless you get one of these "One Man Bleed
Kits".
    If you dont have a Bentley you can find pretty much all the info you
need at the local library. Pay attention to the order the cylinders bled. In
general you start with the cylinder furtherest away from the MC (right
rear), then to the next furtherest (left rear) and so on.
     Make sure you have the proper sized BOX END wrench for the nipples.

----- Original Message -----
From: Debi <mtngal@SIERRATEL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Saturday, May 01, 1999 3:48 PM
Subject: Rebuiliding brake master cylinder


>     Hi,
>     I have a new dilemma,
> My master cylinger is leaking, FLUID BUILD UP AT ME FEET WHILE DRIVING.
> Is it something a newbie can rebuild?
> Should I rebuild it or but one new?
> What is the Cost for a new master cylinder vs kit to rebuild myself....??
> or for reasons unknown to me should I just have one installed...?
> Then there is the time factor, bleeding, & safety...
> Shop prices?
> Sure could use some help here...:0)
>
>                        Mtngal