Volks -- Bentley shows three struts on the left-hand side exhaust for the DigiJet. I have two: from bracket on collector pipe to #4 cylinder exhaust pipe (straight) and from bracket to rear mounting point for left-side tin. Can't figure where the third one is supposed to go -- there is another stud on the #4 pipe flange, so I presume one end goes there. Help? BTW, I'm getting tired of these bloody things rusting to bits, so I'm covering them with braze metal. They cost way too much from the vactory ($25 US for a little 4 inch one), and the homemade ones I've seen have failed from inadequate stress relief at the ends. The braze repairs I've made to rusting ends have been very durable (folded light sheet metal over the end, then fill in with braze metal, grind for stress relief and drill). david David Beierl - dbeierl@ibm.net |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.