At 21:52 5/14/99 -0700, you wrote: >a Bentley manual- see page 26.7 (It says diesel but the layout is exactly >for my van).The difference is I have only 1 bracket from #4 to left exhaust >pipe(has oxy sensor).The other (at 90 degrees) goes from #4 to catalytic >converter where it joins the left exhaust pipe (bolt closest to #4 although >the length of the bracket really determines where). >Hope this helps Ok, Bentley 26.7 was my original source. I'm missing the strut to the cat and you're missing the one from the L-bracket to the bottom rear of the case (where the tin mounts). I'll measure mine if you'll measure yours <g>. I observe in passing that VW in their wisdom made the most complicated possible system *just* for us 83.5-85 owners. It's much simpler both before and after. :-/ d David Beierl - dbeierl@ibm.net |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.