I install a weekender bed, in my GL. Everything was a bolt in except the pins that support the seat back. These pins are moved I think forwards about 3 inches. I could not believe that this was done this way. I ended up removving the plates that were welded into the doner, and welding them into my Van. I am under the impression VW changed the width of the sofa/bed, to accomidate the table side panel. Eric 86-VW4x4 vw4x4@fyi.net 72-240z Pittsburgh, PA USA 1936-Chrysler
On Wed, 26 May 1999, Morrell, Edward wrote: > Does anyone have any experience with swapping out a GL with the interior > from a Carat with the rear facing seats and flip up table. Is this a big > job? > > Ed > 90 Carat 157k miles > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.