Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1999, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 4 Jun 1999 21:50:14 -0400
Reply-To:     David Beierl <synergx@IBM.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <synergx@IBM.NET>
Subject:      Re: pipes?
Comments: To: DChec@AOL.COM
In-Reply-To:  <2e91efd5.2489d1df@aol.com>
Content-Type: text/plain; charset="us-ascii"; format=flowed

Clip the gasket so there are slots at opposite sides leading into the bolt holes...

david

At 21:05 6/4/99 -0400, David Chec wrote: >Does any one out there know if there is a way to replace one pipe gasket w/o >removing more than one pipe? I found my noise problem and have a new gasket >to replace it. Can you remove the stud that goes into the engine block? >This seems as though it would make replacing a single gasket easier. Any >help? > >Thanks > >DChec >84 Westy >99 Jetta

David Beierl - dbeierl@ibm.net


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.