Thanks for the info, Well, I'll use my new 7mm hose clamps and 7mm fuel line in other places, then. I've already had the engine box ones replaced, but not the long ones that run under the van . . . I'll do those, I suppose. Michael -----Original Message----- From: KENWILFY@aol.com <KENWILFY@aol.com> To: townsend@rtp.ericsson.se <townsend@rtp.ericsson.se>; vanagon@gerry.vanagon.com <vanagon@gerry.vanagon.com> Date: Thursday, June 17, 1999 4:13 PM Subject: Re: [VANAGON] Fuel recovery system overhaul Parts
>The stainless ABA clamps that I sell are for 7mm fuel line only. I am pretty >positive that they won't work with the 5mm braided line. However I do sell >the stainless worm drive clamps that will clamp these smaller lines. Because >the lines are not high pressure and because the braiding protects the rubber >of the lines it is safe to use the worm drive clamps on the 5mm low pressure >line (that is how the vans came stock). >The worm drive clamps are a good deal cheaper too. >Ken Wilford >Van-Again >John 3:16 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.