Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1999, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 17 Jun 1999 16:10:41 EDT
Reply-To:     KENWILFY@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         KENWILFY@AOL.COM
Subject:      Re: Fuel recovery system overhaul Parts
Comments: To: townsend@rtp.ericsson.se
Content-Type: text/plain; charset="us-ascii"

The stainless ABA clamps that I sell are for 7mm fuel line only. I am pretty positive that they won't work with the 5mm braided line. However I do sell the stainless worm drive clamps that will clamp these smaller lines. Because the lines are not high pressure and because the braiding protects the rubber of the lines it is safe to use the worm drive clamps on the 5mm low pressure line (that is how the vans came stock). The worm drive clamps are a good deal cheaper too. Ken Wilford Van-Again John 3:16


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.