Date:         Thu, 17 Jun 1999 17:10:11 -0400
Reply-To:     Michael Townsend <townsend@RTP.ERICSSON.SE>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Michael Townsend <townsend@RTP.ERICSSON.SE>
Subject:      Re: Fuel recovery system overhaul Parts
Comments: To: KENWILFY@aol.com
Content-Type: text/plain; charset="iso-8859-1"

Thanks for the info,

Well, I'll use my new 7mm hose clamps and 7mm fuel line in other places,
then.  I've already had the engine box ones replaced, but not the long ones
that run under the van . . . I'll do those, I suppose.

Michael

-----Original Message-----
From: KENWILFY@aol.com <KENWILFY@aol.com>
To: townsend@rtp.ericsson.se <townsend@rtp.ericsson.se>;
vanagon@gerry.vanagon.com <vanagon@gerry.vanagon.com>
Date: Thursday, June 17, 1999 4:13 PM
Subject: Re: [VANAGON] Fuel recovery system overhaul Parts


>The stainless ABA clamps that I sell are for 7mm fuel line only.  I am
pretty
>positive that they won't work with the 5mm braided line.  However I do sell
>the stainless worm drive clamps that will clamp these smaller lines.
Because
>the lines are not high pressure and because the braiding protects the
rubber
>of the lines it is safe to use the worm drive clamps on the 5mm low
pressure
>line (that is how the vans came stock).
>The worm drive clamps are a good deal cheaper too.
>Ken Wilford
>Van-Again
>John 3:16